Cricut EasyPress

Hot Tip

Run a test print on scrap material to ensure all your settings are correct for the best transfer possible.
Prepare

Set Temperature: Preheat the easypress to the recommended temperature (usually around 150-160°C or 300-320°F).

Hard Surface: Set the garment on a hard surface such as a countertop or sturdy table covered with a cloth.

Prepare your Garment: Lay out your garment flat on surface you have chosen. Smooth out any wrinkles and make sure the area where you will place the transfer is flat.

 Position

Place your transfer: Place your transfer onto your garment with the design facing up, and the adhesive against the garment.
Use heat-resistant tape to secure the transfer paper if it is likely to move.

Cover with Parchment Paper: Place parchment paper over top of your transfer to protect the garment and transfer during the process.

 Press

Pressure: Apply firm pressure with the EasyPress to ensure even heat distribution.

Press Time: Hold the EasyPress in place for the recommended time (typically 10-15 seconds) without moving it around to avoid shifting the print.

 Cool Down and Peel

Cooling: Allow the DTF film to cool completely before peeling it off the garment.

Peeling: Once cool, gently peel the film away from the garment, starting from one corner and pulling back slowly to prevent any smudging or incomplete transfer.

 Second Press

Re-Pressing: Place the Teflon sheet back over the design and re-press with the EasyPress for an additional 5-10 seconds.

Final Check: Inspect the print to ensure it has adhered properly and there are no defects.